Skip navigation

A quality Pressure Sensitive Adhesive Hazard Stripe Reflective Marking Tape used to highlight possible hazards which could impact on employee safety.

Unlike general hazard stripe tapes which are non-reflective RFA Hazard Stripe Reflective Marking Tape provides day/night protection, reflective colour during the night and hi viz during the day. The product has been successfully used with:

  • Tradesmen’s tool boxes and equipment which are used on site,
  • Scaffolds, ladders, pallet jacks, barrows
  • Dump bins
  • Shipping containers,
  • Bollards, barriers, warehousing structures and racking,
  • Motor vehicles, fork lifts and allied transport,
  • Traffic hazard points, inside and outside a warehouse,building and external storage areas.

close up of Hazard Stripe reflective marking tape

This product’s specific benefit is highlighting and identifying any item or possible hazard which could potentially cause an accident. The pressure sensitive form of RFA tape allows simple application by trades and handypersons within a company. With difficult and more involved applications it may require a professional installer.

Note: This tape is suitable for application to clean flat metal substrates. It may also be applied to other surfaces but technical advice should be sought prior to application.

If you require more details or samples call or email RFA directly and we shall assist with your enquiries.

hazard stripe reflective marking tape

"RFA Hazard Stripe Reflective Marking Tape provides day/night protection, reflective colour during the night and hi viz during the day"

Available in three grades

each incorporating 3M Brand "Scotchlite" reflective materials

Class 2, Engineer Gradefor general purpose highlighting

Available in:

  • Standard length rolls, 45.7 metres
  • Standard widths, 25mm, 50mm, 75mm, 100mm
  • Colour combinations: White/Red, White/Blue, Red/Yellow, Black/Yellow, White/Green, White/Orange
  • Customised length and width rolls

Class 1 Grade—where a greater level of reflectivity is required

Available in:

  • Standard length rolls, 45.7 metres
  • Standard widths 25mm, 50 mm, 75mm, 100mm
  • Colour combinations: white/red, yellow/black, yellow/red
  • Special lengths and widths can be supplied to meet special needs

Class 1W, Diamond Gradeprovides a superior reflectivity where the utmost visual effectiveness is required, day and night

Available in:

  • Standard length rolls, 45.7 metres
  • Standard widths, 25mm, 50mm, 75mm, 100mm
  • Colour combinations: fluoro red orange/black, fluoro lime yellow/black
  • Non-standard lengths and widths to meet special requirements.

RFA uses and recommends:
3M Scotchlite reflective material

Website by Hope Stewart—Website Design & Management